Updated

Rules & enforcement

CHP puts truck out of service on I-5 over tire defects after speeding stop in Colusa County

A California Highway Patrol officer from the Williams office pulled over a truck on I-5 in Colusa County last week for going more than 20 mph over the limit, found several bad tires and placed it out of service until repairs, CDLLife reports.

According to the CHP, the officer noticed the tire problems on the combination during the traffic stop. The driver got citations for several violations, and the truck could not move again until the tires were fixed. The patrol said it will keep going after speeding and reckless driving in Colusa County, and it asked drivers to check their equipment before each shift.

In California, a truck tractor with three or more axles, or any truck pulling a trailer, has a 55 mph limit, CDLLife noted.

The federal tire rule, 49 CFR 393.75, lists what makes a tire illegal on a commercial vehicle. No tire may show ply or belt material through the tread or sidewall, have a tread or sidewall separation, be flat or leaking audibly, or have a cut deep enough to expose the ply. Steer tires on a truck or tractor need at least 4/32 of an inch of tread in a major groove; every other tire needs 2/32. A regrooved tire rated at 4,920 pounds or more may not go on the front axle of a truck or tractor.

The same section bans carrying more weight than the load rating on the sidewall without a state permit, and running a tire below the cold inflation pressure required for the load. Tires rated for 55 mph or less may not be driven faster than their rating.

Why it matters: A tire that fails 49 CFR 393.75 can end the trip at the roadside. Measure steer tread (4/32 minimum) and look for exposed cords, bulges and leaks on the pre-trip, and keep to 55 mph in California.

Sources

More in rules & enforcement